Page 7

After the final glue up and I've removed the clamps from the table I drill the hole to put the square peg in.

One square peg in the round hole and now on to cutting the mortises in the breadboard end for

 the through table top tenons.

Since I was going to make my table top tenons through tenons and my breadboards ends were four

inches wide I had to cut the mortises in both side of the breadboards.  I put one small drop of glue

on each through tenon then drilled the holes for the square pegs.

The photo on the left shows the pegged through tenon on the table top.  I'm through with the top now

except for the final sanding before I start the finishing process.

The computer table is finally complete now except for a final sanding, making the drawers

and applying the final finish.